User Manual

16
control, then they will be excluded from the add process). To exclude any of the light bulbs that are in
range of the remote control, you must manually turn that light off or remove the light bulb from its fixture
so that no power is being supplied to the light bulb.
3. Make sure your remote control is in range of all light bulbs you are adding.
4. On the remote control, press the following buttons in sequence:
a. {???PRG???} button
b. The numbered button for the lighting group your are adding the light bulb to
c. {???ON???} button
The light bulb(s) dim and then return to their previous level to indicate that they have been added to the
group.
Note: If you attempt to add a light bulb to a lighting group when it already belongs its maximum number of groups,
the light bulb turns off to indicate that the add process failed for that light bulb.
Removing Light Bulbs from a Group
To remove light bulbs from a lighting group:
1. Turn the light bulb on. You can remove multiple light bulbs from the same group at the same time by
making sure they are also turned on. Since turning on the light bulb(s) means turning on the entire
lighting group, all light bulbs in the group turn on together and are therefore part of the removal process
if they are within range of the remote control (if they are not within range of the remote control, then they
will be excluded from the removal process). To exclude from removal any of the light bulbs that are in