User Manual

15
The lights in the group will remember the latest brightness level when you turn them off and on.
Note: The previously selected group (or all groups, if selected) remains the active group on the remote control.
To take action on that same group again, you do not have to press the group button again.
Programming Lighting Groups
By default, each light bulb in your lighting kit is set to a different lighting group during initial installation. You can
change the default settings for the light bulbs to add them to a different lighting group or remove them from an
existing one. You can even add the same light bulb to more than one lighting group.
Adding Light Bulbs to a Group
You can add a light bulb to a maximum of four different lightening groups on one remote control. If you are using
multiple remote controls, the same light bulb can be added to a maximum of eight lighting groups.
To add light bulbs to a lighting group:
1. Make sure the light bulb is installed in a fixture and turn the light bulb on. You can add multiple light
bulbs to the same group at the same time by making sure they are also turned on.
2. If you are adding a light bulb that already belongs to another lighting group, then that entire lighting
group will turn on (since turning on a network light bulb means turning on an entire lighting group). If
there are multiple light bulbs in that lighting group, they will all turn on together and therefore be part of
this add process if they are within range of the remote control (if they are not within range of the remote