User Manual

Before installing the light bulbs, determine the appropriate locations in your home for installing them. The

Lighting Kit Overview chapter provides information on planning your lighting network. When you are ready to

install the light bulbs, perform the following steps:

a. Keep your remote control nearby since you will need it as part of the light bulb installation process.

b. Make sure power to the fixture where you are installing the first light bulb is turned OFF.

c. Install a network light bulb into the fixture as you would any standard light bulb.

d. Turn power to the fixture on. The light bulb begins to brighten and dim while finding the remote control’s

network.

e. While the light bulb is brightening and dimming, press the {???PRG-ON???} buttons on the remote

control. The primary LED light will flash while the light bulb is being added to the network (the remote

control will remain in this mode and flash for approximately five minutes to give you time to install any

remaining light bulbs). When the light bulb has been added to the network, it will turn on at full

brightness.

f. Leave the fixture switch ON so that power is available when using your remote control to turn the light

bulb on and off.

g. Install the next light bulb by repeating steps a – f. Remember, if the primary LED light on the remote

control is still flashing from step e, then it will automatically find the new light bulb without you pressing

any buttons. However, if the LED light has stopped flashing, press the {???PRG-ON???} buttons again

so it can find the new light bulb. Repeat this for each additional light bulb you are adding.

h. When you are finished installing all light bulbs, you can turn the remote control back to normal operation

by pressing the {???PRG-OFF???} buttons. Otherwise the remote control will automatically return to