Owners Manual

DISASSEMBLY

Removing the PURIFICATION PLATE:

Grasp the PURIFICATION PLATE on the ceramic and gently pull it out of the grooves on

the sides. Clean (see “CLEANING” page 16) and set the PURIFICATION PLATE aside.

Removing the PCO CELL:

1. Locate the PCO CELL CONNECTOR on the right of the rear of the purifier almost

halfway up the purifier (beside the PURIFICATION PLATE slot). Squeeze the tabs on

the top and bottom of the PCO CELL CONNECTOR and pull gently until free from

the PCO CELL CONNECTOR Outlet.

2. Remove the PCO CELL RETAINING NUTS from the Screw Posts on the right and left

below the PCO CELL. Place the PCO CELL RETAINING NUTS where you will find

them easily during reassembly.

3. Gently slide the PCO CELL out of the purifier. Clean (see “CLEANING” page 16)

and set the PCO CELL aside.

Clean the interior of the purifier (see “CLEANING” page 16).

Removing the FRONT GRILLE:

1. Locate the four FRONT GRILLE SCREWS in the two upper corners of the FRONT

GRILLE. Using your screw driver, carefully remove the two FRONT GRILLE

SCREWS. Place the FRONT GRILLE SCREWS where you will find them easily during

reassembly.

2. Remove the FRONT GRILLE by tilting the top away from the unit until the FRONT

GRILLE can be lifted free. Ensure that the IONIZATION NEEDLE (in the top center

of the front of the purifier) is not damaged. Clean the FRONT GRILLE if necessary

(using compressed air, vacuum cleaner, damp cloth or warm soapy water) and

set the FRONT GRILLE aside.

3. Clean the IONIZATION NEEDLE if necessary (see “CLEANING” page 16).