Use and Care Manual

SETTING UP SNUG

Plug Orientation

USING SNUG

1. Remove pureHeat SNUG from the packaging.

2. Find an unobstructed outlet to place pureHeat SNUG.

If your desired outlet is upside down, follow these instructions to easily switch the plug

orientation on your pureHeat SNUG to accommodate it.

1. Remove the six (6) Rear Plug Screws around the Rear Plugs.

2. Rotate the Plug in the direction that provides the least resistance.

3. Replace the six (6) Rear Plug Screw.

1. Plug pureHeat SNUG into your desired outlet.

2. Flip the POWER SWITCH, along the right side of the unit, to the ON position.

3. Set your MODE and desired TEMPERATURE using the CONTROL PANEL on the top

of the unit.

FOR YOUR SAFETY, READ ALL WARNINGS & CAUTIONS (PAGE 4) AND USAGE (PAGE 6-7)

BEFORE USING PUREHEAT SNUG.

INSPECT THE UNIT FOR DAMAGE BEFORE SETUP OR USE.

PUREHEAT SNUG WILL NOT WORK WITH A GFCI OUTLET.