Instructions / Assembly
STEP 3:
Right End Wall Assembly.
Set the other END WALL in place. (Figure
4). Ensure that the 1x2 framing is ush
and tight against the 2x2 on FRONT/
BACK END WALL and then secure
following STEP 2 (Fig. 3) using three 1
1/4
”
screws.
Star Cedar Sheds
Deck Box Assembly Instructions
Tools Required:
Drill minimum 12V (or powered)
Phillips bit #2 (or Screwdriver)
Square Torx bit #2
Drill bit 3/64”
Tape Measure
Drill a pilot hole for every screw to
prevent split wood.
(Except where noted.)
STEP 1:
Parts.
Lay out all parts and inventory the parts.
(Figure 1)
STEP 2:
Left End Wall Assembly.
Build deck box on a at surface to ensure
that unit is square when nished. Box is
built upside down. Locate one END WALL
and one FRONT/BACK WALL and place
them on their top edge as shown below
(Figure 2). Ensure that the 1x2 framing
is ush and tight against the 2x2. Screw
from the 1x2 into the 2x2 on the FRONT/
BACK WALL using three 1
1/4
”screws
spaced 2” from either end of the 1x2 and
the third centered between the other two
screws (Figure 3).
Figure 3
Figure 2
STEP 4:
Front/Back Wall Assembly.
Set second FRONT/BACK WALL in place
(Figure 5). Ensure that both corners
are tight and ush, secure each corner
following STEP TWO.
STEP 5:
Base Placement.
Do not pre-drill.
Place the base section on the unit. Setting
it in on an angle (Figure 6). Push oor into
place. The oor should be a tight t and
may require adjusting the box so that it
is square. Secure with one 2
1/2”
” screw
at both center of front and back wall 2x2
where cross support meets. (Figure 7).
Qty
Description
End Wall Panel - 18
3/4
”x23”
Front/Back Wall Panel - 40”x23”
Bottom - 40
1/2
”x20
1/2
”
Lid - 45”x25
1/2
”
Cedar Trim - 1x2x18
3/4
”
1x1/2” Silver Corner Brace
12” Silver Chain
2
1/2”
Screw
1
1/4
” Colored Screw
5/8” Zinc Screw
1
1/4
” Black Screw
2
2
1
1
2
8
2
2
4
32
12
PARTS LIST
Inventory all parts before assembly.
Contact Star Cedar Sheds for any
questions or comments
@ 1-888-659-1832
or
customerservice@
starlumbersheds.com
Do not return to the store you
purchased your kit from. Your parts
will be sent from the factory.
Figure 1
Figure 4
Figure 5
Figure 6
Figure 7
Drill a pilot hole for every screw to
prevent split wood.
(Except where noted.)
Drill a pilot hole for every screw to
prevent split wood.
(Except where noted.)
Drill a pilot hole for every screw to
prevent split wood.
(Except where noted.)
Cross
support