Product Info

Copyright © Green Packet Berhad. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated
into any language, in any form by any means, without the written permission of Green Packet Berhad.
ID DESIGN
APPENDIX
Packing List
Assembled device
Quick installation guide (QIG)
Power adapter
Ethernet cable（Cat.5e）
Environment
Operating temperature: -10~45°C
Storage temperature: -20~60°C
Operating humidity: 5~95%
Storage humidity: 5~95%
Certifications
CE/RoHS/FCC
*Other certifications are available upon request
*The preceding specifications are theoretical values based on product design. Some features and specifications may vary across
markets. To provide accurate product information, specifications, and features, we may make real-time adjustments to the
preceding specifications, so that they match the product performance, specifications, indexes, and components of the actual
product. Product information is subject to such changes and adjustments without notice.
FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any inte
rference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interferenceto radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
To comply with FCC RF exposure compliance requirements, this grant is applicable to only mobile configurations. The antennas used for this transmitter must be installed to provide a separation
distance of at least 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
For Remote control
The device has been evaluated to meet general RF exposure requirement. The device can be used in Mobile exposure condition without restriction.
Caution:
(i) The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;
(ii) For devices with detachable antenna(s), the maximum antenna gain permitted for devices in the band 5725-5850 MHz shall be such that the equipment still complies with the EIRP
limits specified for point-to-point and non-point-to-point operation as appropriate;