User's Manual

Inc.
13
ADAPTOR
71213-20101
STEM DEFLECTOR
07340-00342
SEALED NUT
71213-02200
STEM DEFLECTOR: 71213-20100
Stem Deflector
Accessories
The stem deflector is a very simple alternative to the standard stem
collector and allows access in restricted areas. To replace the stem
collector with the stem deflector proceed as follows:
• A partial rotation and pull movement removes the collector
bottle. The Trigger should be lifted to cut-off the vacuum supply
air prior to removing the collector bottle.
• Fit Stem Deflector (07340-00342) into Adaptor (71213-20101).
• Push the assembled Stem Deflector and Adaptor over Bottle
Adaptor 32 and align with the cut-out feature.
Item numbers in bold refer to the general assembly drawing and parts list on pages 26 and 27.
INNER
71210-20301
OUTER
71210-20302
EXTENSION PART NUMBER: 71210-20300
Fitted between the tool and the nose assembly the extension allows
access into deep channels.
• To fit the extension, remove any nose assembly components.
• Screw the inner extension to Jaw Spreader Housing 41.
• Screw the outer onto Head Assembly 58.
• Fit the nose assembly onto the extension.
• Loosen Locknut 40 using
16mm AF Spanner.
• Unscrew and remove both Jaw
Spreader Housing 41 and
Locknut 40.
• Replace Locknut 40 with
‘Sealed’ Nut 71213-02200,
screw ‘Sealed’ Nut onto Piston
36 to disable Vacuum System.
• Jaw Spreader Housing 41
must be tightened onto Piston
36, finally tightening ‘Sealed’
Nut against it.
Extension
Preparing the Base Tool for use with Stem Deflector
07340-00342
STEM DEFLECTOR
71213-20101
ADAPTOR
41
40
36
‘Sealed’ Nut 71213-02200 replaces Locknut 40 (to cut-off air supply to Vacuum System) as follows: