Owners Manual

ES20LXR
52093315 REV 010 © 2022 Greenlee Tools, Inc.
OLED Screen
The OLED screen displays information about the tool and is used to set up operating proles and display error codes
in the event of abnormal operation (See Troubleshooting). Turn on the screen by inserting the battery and pressing
the trigger.
Cycle through the various displays using the left and right buttons on either side of the screen. The screens will not
cycle after the remote is paired with the tool.
Display OLED Screen Information Shown
0
1
XXX PSI
XXX PSI
P
P
^
Wireless status, battery charge, current pressure, max. pressure. Press and hold both
buttons to change units, select with right button, and confirm by jogging the tool.
2
INFO
123456AB001
FW: 2.0
Firmware version, serial number
3
CURRENT USER : 1
SINGLE CLICK
MRS+
Profile Mode Select screen to choose between Remote and Handheld profile
operations.
4
#ODS #DAYS
Cycles and days until next service.
5
TOTAL:
t=
Q=
n=
1.35 h
8.87 Ah
1560
Elapsed operating hours (T), Ah used (Q), and number of cycles (n) since date of
manufacture.
Table 1: Tool Indicator LED Signals
Signal LED (Red) Meaning Action
Red LED stays lit for 20 seconds after
trigger is released.
Battery Charge Low Change or charge the battery.
LED will flash for 20 sec. after trigger is
released.
Motor current exceeds 20 A during
cycle
Let tool cool.
Tool is Overheated
Flashing light for 20 sec. at end of cycle. Internal Error Send in for Service.
Table 2: Remote LED Signals
Signal
LED
Action
Green Blue
Blue light flashes. Green remains off. Searching for wireless signal.
Blue light solid. Green remains off. Wireless signal found and paired.
Green light flashes and blue light is solid. Tool blade is moving.
Green and blue lights both flash. Remote battery is low.
Green and Blue LEDs solid.
Cut is complete.
(Only for products equipped with end position sensor)
LED Signals