Instructions / Assembly

CAUTION: PRIOR TO FIRST USING THE GENERATOR, THE ENGINE MUST BE

FILLED WITH HIGH QUALITY SAE 10W-30 GRADE ENGINE OIL. TO DO SO,

UNSCREW AND REMOVE THE ENGINE’S OIL DIPSTICK LOCATED AT THE

BOTTOM OF THE ENGINE CRANKCASE. FILL THE ENGINE CRANKCASE UNTIL

THE OIL LEVEL IS LEVEL WITH THE UPPER MARKED LINE ON THE DIPSTICK.

THEN SCREW THE DIPSTICK BACK INTO THE OIL FILL HOLE.

Operation

NOTE: THE PARTS LISTED ABOVE ARE HEL PFUL FOR LOCATING THE

CONTROLS MENTIONED BELOW.

Before Starting the Generator

1. Check that the engine power switch is in its

)snollag

(L0.51:yticapac knat leuF

“OFF” position.

2. Before the first use, remove the fuel

tank cap and fill the fuel tank with unleaded

gasoline. When fueling, be sure that the

fuel strainer is in place. Replace the fuel

tank cap. Thereafter, check the engine’s

fuel gauge for the amount of unleaded

gasoline in the fuel tank. If necessary,

refill the fuel tank with unleaded gasoline;

the generator must be t

urned off and

cooled down before refilling the fuel tank.

Upper Level

Use gasoline with a pump octane rating of 90 or higher.

We recommend unleaded gasoling because it produces

fewer engine and spark plug deposits and extends

exhaust system life. Never use stale or contaminated

gasoline or oil/gasoline mixture. Avoid getting dirt or

water in the fuel tank.

Owne r’s Manual