Owner manual

Harness Connections
Brown / Parking
do not use
Gray
not used
in the US
Turbo
Timer
2-pin connector
Purple / Speed
Parking Brake Feature:
(1) Remove the cover over the parking brake and find the parking
 switch wire(s).
(see you factory service manual)
(2) * If there is one wire, make sure the wire:
 shows 0 volts, when the parking brake is engaged.
 and shows 12 volts, when the parking brake is released.
 * If there are two wires, find the wire that:
 shows 0 volts, when the parking brake is engaged.
 and shows 12 volts, when the parking brake is released.
(3) Route the Brown wire from the 2-pin connector to the parking
 brake switch you found in (2).
(4) Connect the Brown wire to the wire found in (2)
(5) Replace the parking brake cover.

Speedometer / Auto timer Feature:
(Some vehicles do not have a speed signal to connect)
(1) Check your factory service manual for the proper speed signal wire.
(2) Access the speed signal wire on the ECU harness.
(3) Connect the Purple wire to the speed signal wire.
Note: This feature should only be attempted by a trained mechanic,
 serious electrical damage can result form improper installation.
5
Shift lock
release uint
(for Japan only)
12V
0V