Owner manual

Installation

(without Optional Turbo Timer Harness)

(1) Follow the key switch to it’s electrical connector, then unplug the

 harness. Find the appropriate wires with either a factory service

 manual or a volt meter.

(see 2.3 for wiring)

(2) Cut off the 3-pin connector on power harness. Then splice and solder

 the appropriate wires to the power harness.

(be sure to cover connections)

(3) Then connect the black wire with the loop connecter to a good

 chassis ground.( to steel body)

(4) Reconnect the key switch harness.

Important!

A bad ground connection can lead to a mechanical failure, therefore

please attach the ground to a non-painted surface of the vehicles

steel body.

power harness

key switch connector

splice and solder

the appropriate lines

key cylinder

ground wire.

4-pin connector

2-pin connector

Turbo Timer

parking / speed

harness