Product Card

14
15
Product Specification
Instructions
I. Operating
1. Put the product on the neck.
2. Press and hold the button to turn on the machine and voice prompts will be broadcasted. The
automatic combination mode and The colorful LED lights on the right light up;
3. Press and hold the button, voice prompts will be broadcasted and the machine is shut off;
4. The power-on default is combination mode, lowest temperature (38°C) and pressure 1 intensity.
5. Mode 1: Combination Mode 2: Beating Mode 3: Scarping
Mode 4: Acupuncture Mode 5: Kneading
6. when power is on press button Voice prompts will be broadcasted from “Strong heating -- Low
heating -- heating off”
7. Press "M" button to swap to modes from automatic combination mode, beating, scarping,
acupuncture and kneading mode.
8. The strength will restore first level when swapping the mode.
9. Press and hold the “M” button to turn on or off the voice function The content of the announcement
is “Voice On or Voice Off”. There is no pressing tone when the function is off.
10.Press the “+” button to adjust the intensity from 1-16. Short press the “-” button to deduct the
intensity from 16-1. Voice prompts will be broadcasted when adjusting.
11.After starting the machine, the heating function is turned on by default.
12.Preset at 15-minute auto shut-off.
13.The machine will flash white light to indicate power shortage when the battery voltage is lower
than 3.25V. The machine will automatically shut down when the battery voltage is lower than 3.2V.
Please plug in the external power supply to charge until it can be turned on normally. The charging
time is 1.5 hours.
14.For energy saving, the product will be automatically shut down if the electrode is not attached to
the human skin within 2 minutes after the device is turned on.
II. Optional (Some models are equipped with Bluetooth function and remote control)
1. Remote control can use when machine is on. (optional, refer to the remote control manual)
2. Models with Bluetooth function, the device will not shut down by default when the phone is
connected to Bluetooth.
3 The Bluetooth function is always on by default, the mobile phone can be directly paired, the
Bluetooth name is "N303", the mobile phone is successfully connected, you can play music and
make mobile Bluetooth calls.
III. Reharge
1. Please use the USB DC5V adapter to connect the charging cable with the adapter, and the other
end to the USB Type-C interface. The machine's light will show the charging status.
LED light will be white color in breathe mode when charging, white color is on after finish charging.
2. Please use the adapter of USB DC5V, 1A or 2A for charging.
3. The machine cannot be used when charging.
V Daily maintenance
When cleaning and maintenaing this product, please turn off the massager. Use cotton buds
moistened to clean the electrode pads. You may use alcohol (concentration: 75%) for disinfection if
there is any stain.
For daily maintenance, wipe with mild detergent and a soft cloth.
Do not use corrosive detergents. Do not soak or rinse in water.
Water or other liquids should be prevented from penetrating the body during the cleaning process so
as to avoid the risk of short circuit and electric shock during use.