Quick Start Guide
Quick-Start Guide
11 Quick-Start Guide
Quick-Start Guide
Quick-Start Guide 12
Placing A Call
1. Open your Jitterbug.
®
You will hear a dial tone to indicate that there is service available.
2. Dial the full ten digit number using your keypad. If you accidentally press a wrong
button, press the
button to back up and delete the last number.
3. Press the
button to place the call when you are nished dialing.
Using The Phone Book To Make A Call
1. Starting from the Main Screen, use the “Up/Down” button and press the
button when “Phone Book” is highlighted in gray in the middle of the Inside Display.
2. Press the “Up/Down”
button to scroll through the contacts in your Phone Book.
3. When you nd the desired name and number, press the
button to make the call.
You will see “Calling...” on the Inside Display followed by “Connected.”
Receiving A Call
Indicators of an incoming call when your Jitterbug is open:
• The Light Signal on the front of your Jitterbug ashes.
• The phone number of the person calling will appear on the Outside Display.
• If the caller’s number is stored in your Phone Book then the name and number will appear
on the Inside Display. If the caller cannot be identied, you may not see the phone
number or you may see “Unavailable” or “Restricted.”
Receiving a call when your Jitterbug is closed:
1. If the caller’s name and number are stored in your Phone Book or the caller ID is
recognized, either the name or the phone number appears on the Outside Display.
2. Open your Jitterbug when you hear it ring. The Ring Tone will stop when the phone is opened.
1008309_GC_QSG_R1 indd 11-12 10/13/10 12 03 PM