Use and Care Manual

4. Cover all skin, wear gloves, protective clothing and safety
glasses or goggles.
A. Eye contact with wet foam may cause irritation or injury. If
the foam dries and hardens on the eye, it becomes difficult
to remove and will be painful. FIRST AID: Flush eyes with
water for 15 minutes. Seek medical attention.
B. Prolonged skin contact with wet, uncured foam may cause
irritation and may stain skin. Skin contact may cause an
allergic reaction or lead to respiratory sensitization. If wet
or uncured foam gets on skin, quickly and carefully wipe
it off using a cloth without spreading the foam around then
remove residual wet foam using acetone or fingernail polish
remover (with acetone), or a polyglycol-based skin cleanser
or corn oil may be effective. Then wash with soap and plenty
of water. Within minutes, wet foam will dry and bond
to surfaces and skin. Once the foam has dried, it cannot be
removed with any solvents or cleansers. Cured foam that
has dried onto skin or surfaces must be mechanically
removed or allowed to wear off in time. To help remove
cured foam from skin, use a pumice stone (available at most
drugstores) and warm, soapy water. Then apply petroleum
jelly or high quality hand lotion to the affected area to
accelerate the natural sloughing and exfoliation of the skin.
5. The contents are under pressure and should not be stored in
areas of high heat or above 120°F (49°C). Do not store cans in
hot vehicles or around heaters. Do not puncture or incinerate.
Do not store cans in moist environments where the cans could
rust or corrode.
6. Cured foam is combustible and will burn if exposed to
temperatures above 240°F (116°C). Do not apply Great Stuff
™
foam around heaters, high heat lamps or recessed lighting
fixtures, radiators, furnaces or fireplaces where it could contact
heat conducting surfaces. Do not use Great Stuff
™
foam inside
electrical boxes or panels (applications around the outside of
the boxes are permitted).
7. Not for use in aviation, or food/beverage contact, or as
structural support in marine applications.
8. Do not use Great Stuff
™
Insulating Foam Sealants for filling
closed cavities or voids such as behind walls and under tub
surrounds. This improper use of the product could result in the
accumulation of flammable vapors and/or uncured material.
Failure to follow the warnings and instructions provided with
the product, and/or all applicable rules and regulations, can
result in injury or death.
9. Once cured, Great Stuff
™
foam forms a nonhazardous solid
and is nontoxic if ingested by pets. However, it could block the
intestines. If signs of distress are exhibited, seek medical or
veterinary care.
10. One-time use of the can should be expected. Do not force the
nozzle of expired or partially used cans or cans with valves
sealed shut. Foam inside the can continually dries or cures at a
slow rate. Each can is marked with an expiration date, beyond
which the contents may have cured and be unable to spray.
Forcing the nozzle may break it open and allow the contents to
escape. If the can has been used before, the foam will cure in
the nozzle and straw and seal shut within two hours.
For more information visit us at greatstuff.com or call 1-866-583-2583
NOTICE: No freedom from any patent owned by DuPont or others is to be inferred. Because use conditions and applicable laws may differ from one location to another and may change with time, Customer is
responsible for determining whether products and the information in this document are appropriate for Customer’s use and for ensuring that Customer’s workplace and disposal practices are in compliance
with applicable laws and other government enactments. The product shown in this literature may not be available for sale and/or available in all geographies where DuPont is represented. The claims made
may not have been approved for use in all countries or regions. DuPont assumes no obligation or liability for the information in this document. References to “DuPont” or the “Company” mean the DuPont
legal entity selling the products to Customer unless otherwise expressly noted. NO EXPRESS WARRANTIES ARE GIVEN EXCEPT FOR ANY APPLICABLE WRITTEN WARRANTIES SPECIFICALLY PROVIDED BY
DUPONT. ALL IMPLIED WARRANTIES INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE EXPRESSLY EXCLUDED. The buyer assumes all risks as to the use of the
material. Buyer’s exclusive remedy or any claim (including without limitations, negligence, strict liability, or tort) shall be limited to the refund of the purchase price of the material. Failure to strictly adhere to
any recommended procedures shall release DuPont Specialty Products USA, LLC or its affiliates, of all liability with respect to the materials or the use thereof. The information herein is not intended for use by
non-professional designers, applicators or other persons who do not purchase or utilize this product in the normal course of their business.
DuPont Polyurethane Foam Insulation and Sealants
CAUTION: When cured, these products are combustible and will burn if exposed to open flame or sparks from high-energy sources. Do not expose to temperatures above 240ºF (116ºC). For more information,
consult (Material) Safety Data Sheet ((M)SDS), call DuPont at 1-866-583-BLUE (2583) or contact your local building inspector. In an emergency, call 1-989-636-4400 in the U.S. or 1-519-339-3711 in Canada.
Great Stuff
™
contains isocyanate and a flammable blowing agent. Read all instructions and (Material) Safety Data Sheet ((M)SDS), carefully before use. Eliminate all sources of ignition before use. Cover all skin.
Wear long sleeves, gloves, and safety glasses or goggles. Not for use in aviation, or food/beverage contact, or as structural support in marine applications. Provide adequate ventilation or wear proper respiratory
protection. Contents under pressure. Not to be used for filling closed cavities or voids such as behind walls and under tub surrounds; this improper use of the product could result in the accumulation of
flammable vapors and/or uncured material. Failure to follow the warnings and instructions provided with the product, and/or all applicable rules and regulations, can result in injury or death.
Building and/or construction practices unrelated to building materials could greatly affect moisture and the potential for mold formation. No material supplier including DuPont can give assurance that
mold will not develop in any specific system.
DuPont
™
, the DuPont Oval Logo, and all trademarks and service marks denoted with ™,
SM
or ® are
owned by affiliates of DuPont de Nemours, Inc. unless otherwise noted. © 2019 DuPont. 43-D100729-enNA-1219 CDP