Technical Specifications

Dow Building Solutions
Section 3
Operating Instructions
How to prepare and use your FROTHPAK
™
Kit.
FROTHPAK
™
Kit contents
FROTHPAK
™
Kit 115, 160, 120 200 and 210:
2 Tanks of chemical (1 ISO,1 POLYOL)
1 INSTAFLO
™
Dispenser and Hose Assembly
1 Assortment Anti-Crossover Nozzles
1 Petroleum jelly packet
1 Operating Manual
FROTHPAK
™
Kit 620 and 650:
Chemical tank A (ISO) - boxed
Chemical tank B (POLYOL) - boxed
Gun / Hose Assembly Kit - boxed
1 INSTAFLO™ Dispenser and Hose Assembly
1 Assortment Anti-Crossover Nozzles
1 Petroleum jelly packet
1 Operating manual
1 Wrench (5/8”)
Getting the kit ready
1. For users of 115, 160, 120 200 and 210 kit :
The INSTAFLO
™
Dispenser/Hose Assembly is connected to
the chemical tanks. Lift the INSTAFLO
™
Dispenser/Hose
Assembly from the box and fully uncoil hose.
2. Free the perforated section in upper section of the box (near
the locking tab that retained the lid), and bend it down to allow
the hoses to enter into the two cutouts provided. (See figure 1)
3. Apply a coating of petroleum jelly to the inside face of the
INSTAFLO
™
Dispenser. This makes cleaning of the dispenser
face much easier and extends the effective life of the
INSTAFLO
™
Dispenser. (See figure 2)
4. For users of the FROTHPAK
™
620 and 650 kit:
Using the wrench provided in the Gun / Hose Assembly Kit,
tighten the hose assemblies for both “A” and “B” valves until
both are tight. The wrench is intentionally designed to warp or
bend if excessive pressure is applied. Apply a coating of
petroleum jelly to the inside face of the INSTAFLO
™
Dispenser.
(See figure 3)
5. Purge the system into a waste container by activating the
trigger of the INSTAFLO
™
Dispenser. When streams are equal,
release the trigger, clean the chemical from the dispenser face
with a clean rag, and reapply petroleum jelly. (See figure 4)
6. Select an Anti-Crossover Nozzle and insert firmly into the front
of the INSTAFLO
™
Dispenser. Be sure the dispenser clips the
nozzle firmly in place.
6
WARNING
Before using FROTHPAK
™
kits .please read and follow ALL
instructions in this manual. and the SDS