User Manual

❏ 2. Slide the wheels onto the axles, and secure them with
a D6 wheel collar. The flat side of the wheel collar should
be toward the wheel. Secure the wheel collar with a drop of
glue in the teeth opposite the wheels.
❏ 3. Make two wheel pants by gluing the inner and outer
wheel pant parts together. Be sure to make a right and a
left. Glue the inside of both wheel pants to the wheel collars.
❏ 4. Snap the D5 tailwheel into the D4 tailwheel bracket.
❏ 5. Slide the tailwheel bracket over the rudder and rudder
post. Glue the bracket to the rudder only . Do not glue the
bracket to the rudder post.
❏ 1. Glue the elevator servo into the front servo mount in the
left side of the fuselage. The output shaft should be forward.
❏ 2. Glue the rudder servo into the rear servo mount in the
right side of the fuselage. The output shaft should be forward.
Radio Setup
13