Material Rate User Manual

62 1625AHD/AHL Table of Contents Great Plains Manufacturing, Inc.

411-020B Table of Contents 2014-03-17

Conﬁgure PM400 Monitor (Canola)

Refer to Figure 10 (depicting a 1625AHD-32TR30,

U.S. customary units, rows 1-4 in Blockage mode, Row 5 I/O

currently selected, and row 6 in Population mode)

Canola and mustard are singulated seeds when planted

using the 817-991C 250 cell canola seed disk.

1. Press the PLANTER SETUP key. Press the

Right Arrow key to select Conﬁguration 2

This moves the Planter Conﬁguration Indicator

under the “2” in the Conﬁguration block .

2. Use the Down Arrow key ( or ) to move the

input focus to Row I/O at the bottom of the screen.

Press the ENTER to begin altering row I/O. This

auto-selects row 1. Rows default to population

mode (your setup may vary).

3. As each row icon is selected, press the

Up or Down Arrow key ( or )

to change the icon to blockage mode .

4. Press the Right Arrow key ( ) to move to the next

row.

Repeat step 3 and step 4 until all rows are Blockage.

Changes are saved as made.

5. Press the Operate button to begin planting.

Conﬁgure MVT Monitor

These instructions are for the DICKEY-john

MVT (Mini

Virtual Terminal) monitor, singulated seeds and the

monitor in Population mode.

If the planter has recently been used to plant larger

singulated seeds, verify that the SEED ROW SETUP

pattern is changed from “ALL POPULATION” to

“ALL BLOCKAGE”, or set individual rows from

population mode to blockage mode .

b. This convention in this manual is Conﬁguration 1:Singulated/Population, 2:Singulated/Blockage, 3:Volumetric/Blockage.

Figure 10

PM400 Singulate/Blockage Setup

36107

Figure 11

MVT Change Row to Blockage

36224