Operator Manual User guide

68 1300 and 1300F Table of Contents Index Great Plains Manufacturing, Inc.

175-157M Table of Contents Index 2014-04-15

Marker Setup

Marker extension needs to be set up prior to ﬁrst use,

and whenever the marker disk is inverted (page 33) or

the disk angle is signiﬁcantly changed.

Refer to Figure 50

To set up extension for a marker side:

1. Unfold the marker side in ﬁeld conditions. See

“Marker Operation (Option)” on page 26.

2. Lower the drill and openers. Pull forward ten feet

(3 m) or so.

3. At a right angle to the marker or opener furrow,

measure the distance between these two furrows.

For precise one-row offset of opposing passes the

marker extension values should be:

To adjust marker extension:

4. Loosen the nuts on the U-bolts that secure the

marker mount to the drill mainframe.

5. Slide the mount left or right to obtain the desired

marker extension. Secure the U-bolts.

Drill Model Marker Extension

1300-1610

1300F-1610

85.0 inches (215.9 cm)

1300-2175

1300F-2175

82.5 inches (209.6 cm)

1300-2606

1300F-2606

81/0 inches (205.7 cm)

Figure 50

Marker Extension

36273