Operator Manual User guide

10/06/2010 150-290M
Great Plains Manufacturing, Inc. Appendix B - Initial Setup 71
Appendix B - Initial Setup
Installation Instructions
This sections covers initial setup items, and features,
options and accessories ordered later or not factory-
installed.
Figure Callouts
Connector Identification
Refer to Figure 65
JIC - Joint Industry Conference (SAE J514)
Note straight threads and the
37° cone on “M” fittings (or 37° flare on “F”).
ORB - O-Ring Boss (SAE J514)
Note the straight threads and,
elastomer O-Ring .
Fittings needing orientation, such as the ell above,
also have a washer and
jam nut (“adjustable thread port stud”)
Page Installation
72 Initial Setup
76 Scraper Installation
to
callouts identify components in the currently
referenced Figure or Figures. These numbers
may be re-used from page to page.
to
callouts reference new parts. The descriptions
match those on the cartons, bags or item tags,
as well the current Parts Manual.
1 9
11 43
Fittings Torque Values
Fitting Ft-Lbs N-m
9
⁄16 JIC
18-20 24-27
9
⁄16 ORB w/jam nut
12-16 16-22
9
⁄16 ORB straight
18-24 24-32
3
⁄4 JIC
27-39 37-53
3
⁄4 ORB w/jam nut
20-30 27-41
3
⁄4 ORB straight
27-43 37-58
1
3
2
8
7
6
5
4
Figure 65
Hydraulic Connector ID
25188
1
2
3
4
5
6
7
8