Instructions / Assembly

POWER-RIDE GUN RACK

MODEL: UVPR900 & CCPR700

READ ALL INSTRUCTIONS BEFORE USING THE POWER-RIDE GUN RACK

NOTE: Failure to read instructions before use could result in injury or death.

Instructions for Installation and Use:

Fig. 1

Fig. 2 Fig. 3

Contents: See Fig. 1

1 –mounting cradle,

4 –Gun clips, 4 – ¼ " x 1" bolts,

4 -1/4" locknuts, 8 -flat washers

1) Secure stock clips to one side of mounting cradle and barrel clips to opposite side of

mounting cradle using (4) ¼ " x 1" bolts, (8) flat washers, and (4) locknuts (Fig.2 & 3). Tighten

locknuts.

PAGE 1
POWER-RIDE GUN RACK MODEL: UVPR900 & CCPR700 READ ALL INSTRUCTIONS BEFORE USING THE POWER-RIDE GUN RACK NOTE: Failure to read instructions before use could result in injury or death. Instructions for Installation and Use: Contents: See Fig. 1 1 –mounting cradle, 4 –Gun clips, 4 – ¼ " x 1" bolts, 4 -1/4" locknuts, 8 -flat washers Fig.
PAGE 2
) Place the assembled Power Ride Gun Rack on the desired location on the vehicle and secure in place by tightening the pre-installed wing knobs until the gun rack is centered and secured (Fig.4). Fig. 4 3) To transport firearms, place the stock and barrel in the appropriate clips (Fig. 5) and secure in place be fastening the velcro strap (Fig. 6). Fig. 5 Fig.6 NEVER PLACE A LOADED GUN(S) INTO "POWER-RIDE" GUN RACK.