Instructions / Assembly

ManualsBrandsGreat Day ManualsOutdoorsTractor Canopy

PAGE 1 OF 4

“Big Top” ZERO TURN MOWER

“Big Top” TRACTOR CANOPY

CANOPY

MODELS: TAP1000 & LNP1012

READ ALL INSTRUCTIONS BEFORE USING THE ALL PRO OR LAWN PRO CANOPIES

NOTE: ASSISTANCE IS NEEDED WITH THIS PRODUCT INSTALLATION. Failure to read

instructions before use could result in injury or death.

Instructions for Installation and Use:

FIG. 1

CONTENTS: SEE FIG. 1

1 –COMPOSITE TOP WITH FRAME

1 –SET OF 2 UPRIGHT TOP SUPPORTS

4 -3/8” U BOLTS

8 -3/8” FLAT WASHERS

8 -3/8” LOCKNUTS

8 -5/16” X 2 1/4” BOLTS

8 -5/16” LOCKNUTS

16 -5/16” FLAT WASHERS

8 –EXTERNAL TOOTH LOCK WASHERS

2 –MOUNTING PLATES WITH 6 OBLONG

HOLES

2 –MOUNTING PLATES WITH (4) 7/16”

ROUND HOLES

Summary of content (4 pages)

PAGE 1
PAGE 1 OF 4 “Big Top” ZERO TURN MOWER “Big Top” TRACTOR CANOPY CANOPY MODELS: TAP1000 & LNP1012 READ ALL INSTRUCTIONS BEFORE USING THE ALL PRO OR LAWN PRO CANOPIES NOTE: ASSISTANCE IS NEEDED WITH THIS PRODUCT INSTALLATION. Failure to read instructions before use could result in injury or death. Instructions for Installation and Use: FIG. 1 CONTENTS: SEE FIG.
PAGE 2
PAGE 2 OF 4 STEP 2-MEASURE THE ROLL BAR WIDTH ON YOUR TRACTOR OR MOWER. MEASURE THE WIDTH OF THE TRACTOR TOP FRAME. SEE FIG. 2 FIG. 2 STEP 3-INSTALL MOUNTING PLATES WITH OBLONG HOLES TO CANOPY USING 5/16” BOLTS, FLAT WASHERS, EXTERNAL TOOTH LOCK WASHERS AND LOCK NUTS PROVIDED. **NOTE**EXTERNAL TOOTH LOCK WASHERS MUST BE INSTALLED BETWEEN MOUNTING PLATES AND CANOPY FRAME. **SEE FIG. 3 FIG. 3 **NOTE**MOUNTING PLATES CAN BE MOUNTED TO THE INSIDE SEE FIG. 4 OR OUTSIDE SEE FIG.
PAGE 3
PAGE 3 OF 4 STEP 4-ATTACH UPRIGHT SUPPORTS TO MOUNTING PLATES WITH OBLONG HOLES AS DONE IN STEP 3. *NOTE*SELECT THE APPROPRIATE HOLES OF THE 3 SETS AVAILABLE TO ACQUIRE THE DESIRED ANGLE FOR YOUR TRACTOR TOP/CANOPY.* **NOTE**THESE BOLTS SHOULD BE LEFT SOMEWHAT LOOSE UNTIL FINAL ASSEMBLY HAS BEEN COMPLETED. ** SEE FIG. 4 FIG. 4 STEP 5-ATTACH 3/8” U-BOLTS TO VERTICAL SIDES OF ROLLBARS USING 3/8” FLAT WASHERS AND 3/8” LOCK NUTS PROVIDED.
PAGE 4
PAGE 4 OF 4 STEP 7-BY UTILIZING THE RANGE OF MOVEMENT PROVIDED WITH THE OBLONG HOLES IN THE MOUNTING PLATES, HOLD CANOPY HORIZONTAL TO GROUND. TIGHTEN ALL HARDWARE SECURELY. SEE FIG. 7 FIG. 7 CANOPY DOES NOT OFFER ANY ADDITIONAL ROLLOVER PROTECTION. NEVER ALLOW ANYONE TO SIT OR STAND ON CANOPY. CANOPY IS NOT INTENDED TO TRANSPORT ANY CARGO AND/OR EQUIPMENT. For more information about this or other products, contact us at: Great Day, Inc. 604 Kimbrough Dr. * Tallulah, LA 71282 * (866) 649-1918 * www.