Instructions / Assembly

ManualsBrandsGreat Day ManualsTools & HardwareRide-N-Rest for ATV

RIDE-N-REST

MODEL: RR605B

READ ALL INSTRUCTIONS BEFORE USING THE RIDE-N-REST

NOTE: Failure to read instructions before use could result in injury or death.

Instructions for Installation and Use:

FIG. 1

CONTENTS:SEE FIGURE 1

1 - RIDE-N-REST FRAME ASSEMBLY

WITH CUSHION

4 – SLIDING MOUNTING BRACKETS

4 – RIV-NUT PLATES

4 – QUICK PINS

4– 1” MULTI PLUGS

8 – ¼” X 2 ¾” BOLTS

8 – ¼” X 1 ¾” BOLTS

8 – FLAT WASHERS

Summary of content (4 pages)

PAGE 1
RIDE-N-REST MODEL: RR605B READ ALL INSTRUCTIONS BEFORE USING THE RIDE-N-REST NOTE: Failure to read instructions before use could result in injury or death. Instructions for Installation and Use: CONTENTS:SEE FIGURE 1 1 - RIDE-N-REST FRAME ASSEMBLY WITH CUSHION 4 – SLIDING MOUNTING BRACKETS 4 – RIV-NUT PLATES 4 – QUICK PINS 4– 1” MULTI PLUGS 8 – ¼” X 2 ¾” BOLTS 8 – ¼” X 1 ¾” BOLTS 8 – FLAT WASHERS FIG.
PAGE 2
STEP 1 – SLIDE THE 4 MOUNTING BLOCKS ONTO HORIZONTAL BARS OF RIDEN-REST FRAME. SEE FIGURE 2 FIG. 2 STEP 2 – ATTACH 4 SLIDING MOUNTING BLOCKS IN DESIRED POSITIONS USING 4 QUICK CLIP PINS PROVIDED. SEE FIGURE 3 FIG. 3 STEP 3 – USING A RUBBER MALLET OR HAMMER DRIVE THE 2 – 1” MULTI PLUGS INTO OPEN ENDS OF THE HORIZONTAL BARS OF THE RIDE-N-REST FRAME. SEE FIGURE 4 FIG.
PAGE 3
STEP 4 – POSITION RIDE-N-REST FRAME ONTO CENTER OF ATV REAR RACK TO MAKE SURE THE 4 SLIDING MOUNTING BLOCKS ARE IN THE PROPER POSITION FOR RIDE-NREST TO BE SECURED TO ATV RACK. SEE FIGURE 5 FIG. 5 STEP 5 – ATTACH RIDE-N-REST SLIDING MOUNTING BLOCKS TO ATV RACK USING 4 – RIV-NUT PLATES, 8 – FLAT WASHERS AND 8 – ¼” X 1 ¾” BOLTS OR 8 – ¼” X 2 ¾” BOLTS (DEPENDING ON THICKNESS OF ATV RACK). FINGER TIGHTEN BOLTS UNTIL SNUG, BUT NOT COMPLETELY TIGHT. SEE FIGURE 6 FIG.
PAGE 4
STEP 7 – TO SECURE RIDE-N-REST CUSHION, REMOVE THE 2 FRONT QUICK CLIP PINS FROM THE MOUNTING BLOCKS, PIVOT CUSHION TO DESIRED ANGLE AND PIN VERTICAL SUPPORT BARS TO HORIZONTAL FRAME BARS THEN REPLACE QUICK CLIP PINS. SEE FIGURE 8 FIG. 8 STEP 8 – TO LAY BACKREST IN HORIZONTAL POSITION REMOVE 2 QUICK CLIP PINS FROM VERTICAL SUPPORT BARS, LAY BACKREST FLAT AND REPLACE QUICK CLIP PINS INTO SLIDING MOUNTING BLOCKS. SEE FIGURE 9 FIG. 9 NEVER USE THE RIDE-N-REST FOR ANY PURPOSE OTHER THAN INTENDED.