Instructions / Assembly

FIG. 3
FIG. 4
FIG. 5
FIG. 6
PAGE 3 OF 3
STEP 2 –
ATTACH 4 SLIDING MOUNTING BLOCKS IN
DESIRED POSITIONS USING 4 QUICK CLIP
PINS PROVIDED. SEE FIG. 3
STEP 3 –
USING A RUBBER MALLET OR
HAMMER, DRIVE THE 6 – 1”
MULTI PLUGS INTO OPEN ENDS
OF THE HORIZONTAL BARS OF
THE RIDE-N-REST FRAME. SEE
FIG. 4
STEP 4 –
POSITION RIDE-N-REST FRAME
ONTO CENTER OF ATV REAR RACK
TO MAKE SURE THE 4 SLIDING
MOUNTING BLOCKS ARE IN THE
PROPER POSITION FOR RIDE-N-
REST TO BE SECURED TO ATV
RACK. SEE FIG. 5
STEP 5 –
ATTACH RIDE-N-REST SLIDING
MOUNTING BLOCKS TO ATV RACK
USING 4 – RIV-NUT PLATES, 8 –
FLAT WASHERS AND 8 – 1/4” X 1
3/4” BOLTS OR 8 – 1/4” X 2 3/4”
BOLTS (DEPENDING ON THICKNESS
OF ATV RACK). FINGER TIGHTEN
BOLTS UNTIL SNUG, BUT NOT
COMPLETELY TIGHT. SEE FIG. 6