Instructions / Assembly

PAGE 1 OF 3

RIDE-N-REST

MODEL: RR605B

READ ALL INSTRUCTIONS BEFORE USING THE RIDE-N-REST

NOTE: Failure to read instructions before use could result in injury or death.

Instructions for Installation and Use:

FIG. 1

FIG. 2

PAGE 2 OF 3

CONTENTS:SEE FIG. 1

4 – SLIDING MOUNTING BRACKETS

4 – RIV-NUT PLATES

4 – 2” QUICK CLIP PINS

6– 1” MULTI PLUGS

8 – 1-4” X 2 3/4” BOLTS

8 – 1/4” X 1 3/4” BOLTS

8 – FLAT WASHERS

1 - RIDE-N-REST FRAME ASSEMBLY WITH

CUSHION

STEP 1 –

SLIDE THE 4 MOUNTING BLOCKS

ONTO HORIZONTAL BARS OF

RIDE-N-REST FRAME. SEE FIG. 2

PAGE 1
PAGE 1 OF 3 RIDE-N-REST MODEL: RR605B READ ALL INSTRUCTIONS BEFORE USING THE RIDE-N-REST NOTE: Failure to read instructions before use could result in injury or death. Instructions for Installation and Use: FIG. 1 CONTENTS:SEE FIG. 1 4 – SLIDING MOUNTING BRACKETS 4 – RIV-NUT PLATES 4 – 2” QUICK CLIP PINS 6– 1” MULTI PLUGS 8 – 1-4” X 2 3/4” BOLTS 8 – 1/4” X 1 3/4” BOLTS 8 – FLATFIG.
PAGE 2
STEP 2 – ATTACH 4 SLIDING MOUNTING BLOCKS IN DESIRED POSITIONS USING 4 QUICK CLIP PINS PROVIDED. SEE FIG. 3 FIG. 3 STEP 3 – USING A RUBBER MALLET OR HAMMER, DRIVE THE 6 – 1” MULTI PLUGS INTO OPEN ENDS OF THE HORIZONTAL BARS OF THE RIDE-N-REST FRAME. SEE FIG. 4 FIG. 4 STEP 4 – POSITION RIDE-N-REST FRAME ONTO CENTER OF ATV REAR RACK TO MAKE SURE THE 4 SLIDING MOUNTING BLOCKS ARE IN THE PROPER POSITION FOR RIDE-NREST TO BE SECURED TO ATV RACK. SEE FIG. 5 FIG.
PAGE 3
STEP 6 – RE-CHECK RIDE-N-REST TO BE SURE IT IS CENTERED ON ATV RACK AND TIGHTEN BOLTS SECURELY USING A 7/16” WRENCH. SEE FIG. 7 FIG. 7 STEP 7 – TO SECURE RIDE-N-REST CUSHION, REMOVE THE 2 FRONT QUICK CLIP PINS FROM THE MOUNTING BLOCKS, PIVOT CUSHION TO DESIRED ANGLE AND PIN VERTICAL SUPPORT BARS TO HORIZONTAL FRAME BARS THEN REPLACE QUICK CLIP PINS. SEE FIG. 8 FIG. 8 FIG.