795-90914 0812 Operation and Maintenance Instructions Tempest™ Jet Spray Cabinet T-10, T-10S and T-20S
SAFETY WARNINGS You will find various types of safety information on the following pages and on the labels attached to Graymills equipment. The following Safety Statements explain their meaning: This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. Unit must be properly grounded to prevent electric shock hazard. Connect only to three prong outlet.
SITE PREPARATION Before installing, careful consideration should be given to the place of operation. Place unit on a smooth, level surface. Use leveling feet to correct for minor variations in floor. Place Tempest near a 115V, 60Hz, 1-ph grounded electrical outlet. You will also need compressed air, maximum of 100PSI. The work area should be well ventilated and lit. Provide adequate lighting in the work area to permit viewing of the cleaning process and of the floor area around the machine.
• Close spray chamber door and secure door hasps • Place hands in gloves, secure the part, grip spray hose firmly, direct hose at parts and depress foot pedal to activate spray. Adjust nozzle for desired spray pattern. • If unit will be idle for an extended period, door should be latched in open position. • If equipment is used in near freezing conditions, protect pump after use by draining cleaning fluid, then pumping antifreeze solution through system. This will coat the pump interior.
OPTIONAL AIR BLOW-OFF NOZZLE An internal air blow-off is an option of the Tempest 20S. The air is supplied from the Customer’s compressed air system, 100 PSI maximum. The hose and nozzle are to be used for drying off parts but are also useful for cleaning and drying the chamber. OPTIONAL OIL SKIMMER (TEM-OSK) The Oil Skimmer is another option of the Tempest 20S. Its purpose is to remove tramp oil from the top of the reservoir and should be operated as necessary.
Tempest™ T-10, T-10S Parts List Ref# Part No Electrical 1 770-07011 2 770-04190 3 770-07024 4 770-07025 6 780-91124 7 780-38043 8 780-07010 39 772-07017 43 777-09499 Description Door Safety Switch (Push Type) Main Control Switch Foot Pedal Foot Control Switch (inside) Thermostat Heater Relay - 30 Amp Light Assembly Switch, GFI Pump and Motor 9 390-90894 10 369-90893 11* 743-07172 12** 743-07171 Piston Pump Pump Motor - 1 HP Piston Pump Valve Assy Kit Piston Pump Stack and Guide Kit Blower System 14 738
Tempest™ T-20S Parts List Ref# Part No Electrical 1 770-07011 2 770-04190 3 770-07024 4 770-07025 5 770-90905 6 780-91124 7 780-38043 8 780-07010 9 772-07017 43 777-09499 Description Door Safety Switch (Push Type) Main Control Switch Foot Pedal Foot Control Switch (inside) Skimmer Switch Thermostat Heater Relay - 30 Amp Light Assembly Switch, GFI Pump and Motor 10 390-90894 11 369-90893 12* 743-07172 13** 743-07171 Piston Pump Pump Motor - 1 HP Piston Pump Valve Assy Kit Piston Pump Stack and Guide Kit
Warranty Graymills Corporation warrants that the equipment manufactured and delivered, when properly installed and maintained, shall be free from defects in workmanship and will function as quoted in the published specification. Graymills does not warrant process performance, nor assume any liability for equipment selection, adaptation, or installation.
