User Manual

Adam Hall GmbH · Daimlerstr. 9 · 61267 Neu-Anspach · Germany
Tel.: (+49) 60 81 / 94 19 0 · Fax: (+49) 60 81 / 94 19 1000 · eMail: [e-mail]
SAFETY INFORMATION
1. Please read these instructions carefully before you start installation and assembly.
2. Keep all information and instructions in a safe place.
3. Follow the instructions.
4. Observe all safety warnings. Never remove safety warnings or other information
from the equipment.
5. Be attentive when setting up the product and protect yourself from injury.
6. This product is intended for indoor use only. Using it outdoors could lead to
product failure and personal injury.
7. Do not modify this equipment.
8. Comply with all applicable disposal laws in your country. During disposal of
packaging, please separate plastic and paper/cardboard.
9. Plastic bags must be kept out of reach of children.
10. If you have any questions refering to this instruction or any warnings, please
contact your local distributor.
MANUFACTURER’S WARRANTY & LIMITATION OF LIABILITY
You can find our current warranty conditions and limitation of liability at: http://www.
adamhall.com/media/shop/downloads/documents/manufacturersdeclarations.
pdf
To request warranty service for a product, please contact Adam Hall GmbH,
Daimler Straße 9, 61267 Neu Anspach / Email [e-mail] /
49 (0) 6081 / 9419-0
PROPER DISPOSAL OF THIS PRODUCT
(WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT)
(Valid in the European Union and other European countries with waste
separation)
This symbol on the product, or the documents accompanying the product, indicates
that this appliance may not be treated as household waste. This is to avoid environ-
mental damage or personal injury due to uncontrolled waste disposal. Please dis-
pose of this product separately from other waste and have it recycled to promote
sustainable economic activity.
FEATURES
Heavy duty zinc diecast material
Rubber spacer included for acoustic decoupling
Locking nut included
3/8” Adapter included
Screw set included
INTRODUCTION
The Gravity Mic Clip Dock permanently mounts to cabinets and combo amps to
facilitate speaker micing. It features a large retainer and comes with a rubber spacer
to isolate the assembly from surface vibrations. A 3/8“ to 5/8“ adapter is included.
SPECIFICATIONS
Product type: Microphone holder
Material: die-cast
Colour: black
Surface: powder coated
Threaded Connector: 3/8”, 5/8”
Width: 42 mm
Depth: 48 mm
Height: 30 mm
Weight: 0.12 kg
Additional Information: screw set and und rubber for decoupling
included
GMSAMPDS01
Microphone Dock for mounting on guitar ampliers and cabinets