Operation Manual

Page 52/53
15. SPECIFICATION
Battery:
Charge currents / power 100 mA to 10.0 A / max. 120W overall with internal power supply
100 mA to 10.0 A / max. 2x 180 W for using both outputs or 1x 250W for
using just one output with external 11...15V DC power supply
Discharge currents / power 100 mA to 10 A / max. 80 W
Ni-Cd & Ni-MH batteries:
Cell count 1 - 18 cells
Capacity min. 0.1 Ah to 9.9 Ah
Lithium batteries:
Cell count 1-7 cells
Cell voltage 3,3 V (LiFe), 3,6 V (LiIo) / 3,7 V (LiPo/LiMn)
Capacity min. 0.1 Ah to 20.0 Ah
Lead-acid / lead-gel batteries:
Cell count 1, 2, 3, 4, 5, 6, 12 cells
Battery voltage 2, 4, 6, 8, 10, 12, 24 V
Capacity 0.1-45 Ah
General:
Operating voltage range DC input 11,0 to 15 V
Operating voltage range AC input 100 ~ 240V
Car battery required 12 V, min. 50 Ah
Mains PSU required 11-15V, min. 5-40A stabilized
1)
No-load current drain approx 0.3…0.6 A
balancer connector: 1...7 NiMH/NiCd/LiPo/LiIo/LiFe cells
balancing current: NiMH/NiCd: 0.1A, LiPo/LiIo/LiFe: 0.3A
Low-voltage cut-off approx 11,0 V
Weight approx. 2.2kg
Dimensions approx. (W x D x H) 230 x 225 x 83 mm
All data assumes a car battery voltage of 12.7 V.
The stated values are guidelines, and may vary according to battery state, temperature etc.
1)
When powered by a main PSU, the charger will only operate correctly if the PSU is suitable in terms
of voltage, stability, maximum load capacity etc. You can avoid problems by using only the PSUs
which we specifically recommend.
Environnemental Protection Notes