User manual

23 / 28
S5012_Alpha_110_jh_V1
The S5012.RFH version has a big white LED on the front. To
switch the LED on program a mixer on your transmitter to chan-
nel 6 with -100%. With the LED on the Auto-flip function is not
available.
Receiver's base settings
TYPE
Quadro x, Quadro +, Tri L, Tri R
Here it must always be selected in this model the setting Quadro X.
MODE
ESC settings for the learning of the controller the receiver K1 sig-
nal will be passed directly to the controller.
Normal is set for ‘normal‘ multicopter. (Must always be selected)
Acro 3D should not be selected for this model because this
model is not suitable for this function.
Note:
For safety reason the Type and Mode changes take effect after
switching off and on (only for this parameter).
Minpower%
The setting is principally used to prevent the motors shut down
in flight. Adjust so that the motors are running straight. Under no
circumstances unnecessarily high set, this would limit the con-
troller possibilities.
CALIBR. POSITION
With Calibr. Position the acceleration sensors can be calibrated
so that in attitude mode with stick and trim neutral, the copter
is precisely horizontally aligned. For this purpose, it is simply
placed on absolute level surface and set the value to Yes. After
a moment, it jumps back to No and the calibration is done. Do
not forget to store disabling the field!
Axis assignment
Setup: Setup: Yes/No
Assignment of the gyros and their operating direction.
In the receiver’s “Axis assign” menu, go to the “Setup” option
and set it to “Setup: Yes”. Now assign the axes as follow:
On the transmitter, briefly set the roll command fully to the right;
the roll axis is highlighted. Roll the copter more than 45 degrees
to the right the identified axis with the required prefix is dis-
played, the field is no longer highlighted and identification of this
axis is complete.
Now do the same for nick: on the transmitter, briefly set the nick
command so that it is fully forward. Roll the copter more than
45 degrees forwards; the axis is displayed, the field is no longer
highlighted and identification of this axis is complete.
LED On/Off
(Version S5012.RFH)
Multicopter Basis< v >
>Type Quadro X
Mode NORMAL
Minpower % 10
Calibr. Posit. No
Axis assignment <
>Setup No
ROLL +0
NICK +0
YAW +0
Step 3
Axis assignment in the gyro