User manual

22 / 28
S5012_Alpha_110_jh_V1
Camera function by version S 5012.FPV
Through the installed camera and the video transmitter is emit-
ted a video signal. The transmission starts as soon as you con-
nect the copter battery. Scan the transmission signal of the cop-
ter in your video goggles or video monitor.
The video channel switching will be described in the next sec-
tion Special functions. (Channel list see “technical data”)
Setting in connection with HoTT transmitter with display
Transmitter settings
If you use a HoTT transmitter with display to control the copter,
you will have the following setting options through the transmit-
ter telemetry menu:
In the transmitter it must be selected a free model memory, the
model type must be “surface model“ and the channel 1 direction
must be set so that in “motor off“ position the channel 1 power
indicator must show -100%.
The flight mode must be set on channel 5. For this program a
2-way switch (e.g. switch 3) in the transmitter control menu on
Channel 5 as follows:
Attitude mode: Channel 5 = -100% to +50%. The stick move-
ment determines the Copter reaction on Roll and Nick. It allows
a maximal angle of about 50° at 100% of stick movement. Mode
suggested for beginners. The stick movements acts directly
proportionally to Roll and Nick.
Rate mode: Channel 5 = more than +50%. The stick movement
determines the rate without angle limit. Aerobatic mode that
allows rolls and loopings.
Special functions channel 6
Through the transmitter channel 6 it is possible to activate the
special functions (Auto-flip, video channel switch, LED On/Off Ver-
sion S5012.RFH)
Four video channels are available. Thus program on the trans-
mitter in the controls menu a switch for channel 6 with +100%.
Push the switch for two seconds to switch the channel. The
channel switches each time one position.
It allows you to flip your copter in a very easy way. It is essential
that you control in Attitude mode (function not allowed in Rate
mode).
The auto-flip function must be controlled by a switch assigned in
a free mixer on your transmitter to the channel 6 with +110%.
Activate the switch and within 5 sec move the nick or roll stick
to more than 50% of its course, then the copter makes auton-
omously a flip in the selected direction. After the flip it is possible
to have some little position movements (<10°).
Function channel 5
Setting of the flight-mode :
attitude or rate mode
E5
– TRV +
+100%
E6
+100%
+100%
+88%
+100%
3
Video channel switch
Auto-flip function