User manual

19 / 28
S5012_Alpha_110_jh_V1
Stick calibration
If the center position of your self-neutralizing control stick does
not precisely correspond to 0% control travel, you can check
and correct it as follows.
Stick calibration step by step:
• Bring the transmitter to the programming mode by pushing
and holding the left stick while switching on the transmitter.
• The red LED blinks 3 times to confirm the programming
mode.
• Move both sticks to all direction and then back to the middle
position.
• After that leave the sticks for about 3 seconds in the middle
position.
• To confirm the correct sticks calibration the red and the green
LED blink 3 times simultaneously.
• After checking LED, press stick button for a while to save.
• If this blink signal is not emitted, repeat the entire procedure.
Factory reset
If it was necessary to erase all the values saved in the copter and
to recall the factory settings you can operate a factory reset.
Therefor proceed as follows:
Attention! All model settings will be erased!
Push all the trims to the inside and then switch the transmitter
on. In this way all the saved values will be deleted and reset to
the factory settings.