User manual

ManualsBrandsGRAUPNER ManualsQuadrocopter, MulticopterAlpha 110 Quadcopter RtF

14 / 28

S5012_Alpha_110_jh_V1

Controls directions Mode 3 - 4

Preparation before use

The following components are required to use the model: Trans-

mitter HoTT (MZ-8 / MX-12 / MZ-12 or higher) MZ-8 included

by S5012.RTF.

For the version S5012.FPV will be required a video goggle or an

FPV monitor to fly in FPV.

Receiver

The transmitter is already completely set for Alpha 110 Quadcop-

ter. To program some parameters, refer to the section "Receiver

settings". (only possible with HoTT transmitter with display)

Installing the battery in the copter

Insert the battery in the battery case. Push the battery com-

pletely inside its compartment so that the Alpha 110 Quadcopter’s

center of gravity is in the middle.

Binding the receiver

The included receiver is already bound to the MZ-8 transmitter

in the version S 5012.RTF. In the other versions without included

transmitter, you can bind the copter receiver with your favorite

HoTT transmitter. Thereto read the manual of your HoTT trans-

mitter. The copter receiver is already in binding mode as soon

as it is switched on. Then simply start the binding process in the

transmitter.

Binding with the MZ-8 transmitter

If you want to bind the copter with the MZ-8 transmitter push

the "LED" button on the transmitter when the copter is switched

on.

If the binding process was successful the status LEDs will light

red on the transmitter and green on the copter.

Nick forward

Nick backward

Roll left

Roll right

Throttle full

Motor idle

Yaw left

Yaw right