Operation Manual

Touch

Touch Touch

Touch

9-4. FLAP >> ELEV

This mixing prevents the change of the nose of airplane that occurs when FLAP is applied

by operating elevator In FLAP MIX page, touch “INH” icon in ACT line to switch to “ON” then

FLAP >> ELEV function is activated. Touch “ON” in CTL line to call the “Select” message pop-

up and move the switch or stick or volume with your choice then that switch or stick or volume

is designated as on/ off key and then the key direction setup page appears. You may select

ON or OFF by touching icons. When the key is moved to the direction of ON, the function

is operated. Touch “BACK” icon to return to FLAP MIX page. Touch “>>” icon in “SET” and

“FLAP >> ELEV” cross line to call “FLAP >> ELEV” setup page. Touch and activate the values

in blue and adjust them with INC and DEC buttons. When the setup is completed, touch

SERVO icon on the top right to call SERVO page. You may check the setup value for “FLAP

>> ELEV”. The preset set “FLAP” and the set “FLAP >> ELEV” are activated at the same time

when SW5 which was set in “FLAP >> ELEV” is set to “ON”.