Operation Manual

Touch

Telemetry

6-2. Curve mixing type

In the prog.mix page, touch “NEXT” icon to call the next page and touch “INH” icon in the

cross line of NO7 and ACT to switch to “ON”. Touch “NONE” in MST line to access the

channel selection page and touch and activate “NONE” icon to select the desired channel of

MST and SLV. Touch “BACK” icon to return to the prog.mix page. Touch “>>” icon to call the

program mixing setup page. Now, you need to set CTL function.

- CTL setup with a switch

Touch “ON” icon in CTL line to call “Select” message popup then move the switch with your

choice then that switch is designated as on/ off switch and then the switch direction setup

page appears. You may select ON or OFF by touching icons. When the switch is moved to the

direction of ON, the function is operated. Touch “BACK” icon to return to the program mixing

setup page.

- CTL setup with a stick

Hoping that you would refer the explanation as explained above

Here, you need to set the operation value, “L” and “H” points are set by default and you need

to mark 5 points between “L” and “H” on graph rst and then adjust the operation curve with

“DEC”, “INC”, X-axis and Y-axis buttons. Touch “ST OFF” icon to switch to “ST ON” then

the blue line appears on graph. Move the designated switch or stick to place the line at the

desired position then touch “ENT” icon on the bottom right. Now the new point is marked in

graph. You may set ve points in your favorable position.

Touch

ACT

CTL

ACT

CTL

Touch “PITT >> RUDD” icon in the function page to call PIT >> RUDD setup page. You need

to mark the point on graph rst and then adjust the operation curve with “DEC”, “INC”, X-axis

and Y-axis buttons. Touch “ST OFF” icon to switch to “ST ON” then the pitch position line

appears on graph. Move throttle stick and place the line at the desired position between point

“L” and “H” then touch “ENT” icon on the bottom right. Now the new point is marked in graph.

Touch ST ON” to switch to “ST OFF” and complete the point setup. Now touch “DEC” or “INC”

button to select point and touch X-axis or Y-axis to activate and then touch DEC” or “INC”

button to adjust the operation curve.