Operation Manual

Touch

Telemetry

Touch

In FUNCTIOPN page, touch “THR.CRV” icon to call THR.CRV setup page. You need to mark

the point on graph rst and then adjust the operation curve with “DEC”, “INC”, X-axis and Y-axis

buttons. Touch “ST OFF” to switch to “ST ON” then the throttle position line appears on graph.

Move throttle stick and place the line at the desired position between point “L” and “H” then

touch “ENT” icon on the bottom right. Now the new point is marked in graph. You can mark ve

points between point “L” and “H” in the same way. Touch ST ON” to switch to “ST OFF” and

complete the point setup. Now touch “DEC” or “INC” button to select point and touch X-axis or

Y-axis to activate and then touch DEC” or “INC” button to adjust the operation curve. Turn on

the preset Q.LINK switch then you may adjust the operation curve for every Q.LINK as well.

When the setting is completed, touch “BACK” icon to return to the function page.