Operation Manual

Touch

•

ALARM TEMP +/-

It is the alarm setup for the maximum/minimum temperature of receiver. Transmitter sounds

an alarm throughout telemetry technology when the temperature of receiver reaches the

temperature limits.

Touch “SET” icon to activate the value in red and adjust the value with INC and DEC buttons.

Touch “SET” icon again to deactivate the value. Touch INC button to move the cursor to “CH

OUT TYPE”

- CH OUT TYPE

It is used to set the type of receiver’s signal output and it consists of ONCE, SAME, SUMO 12,

SUMI, and SUMD HD12.

> ONCE : This type is applied to the analog servo. “20msec” is automatically set to PERIOD in

RX SERVO setup

> SAME : This type is usually applied to the digital servo. You need to “10 ~ 20msec” to

PERIOD. In case that the analog servo is connected, you need to set “20msec” to

PERIOD.

> SUMI : The receiver set to SUMI take the output signal from the receiver set to SUMO and

outputs the signal.

> SUMO : Only the selected channel outputs the signal of all channels of receiver. In case that

1 receiver is set to SUMO and the other receiver is set to SUMI and then they are

connected in ex code, the receiver set to SUMI take the output signal from the re-

ceiver set to SUMO and it is operated at the same time. The nal channel of receiver

is the output channel of SUMO, but you may change to the desired channel.

> SUMD HD : The digital output signal of all channels in receiver is outputted from the select-

ed channel. It is used to the product that needs the receiver digital signal such

as Power box and Flybarless system. The factory default for SUMD HD output

channel is the last channel of receiver, but you may change it