Operation Manual

Touch

•

PERIOD

It is used to set the speed of receiver’s output signal.

Touch “SET” icon to activate the default value, 20msec, in red and set the value to 10msec

with INC and DEC buttons. Touch “SET” icon again to deactivate the value and touch ENT

button to call “RX FAIL SAFE” setup page

- RX FAIL SAFE

•

OUTPUT CH/ INPUT CH

You may edit and adjust transmitter channel which is connected with a receiver using “OUT-

PUT CH” and “INPUT CH”. Receiver CH1, 2, 3, 4, 5, 6 are connected to the same channels of

transmitter as the default and you may edit the channel connection of receiver and transmitter.

Since OUTPUT CH is changed if INPUT CH would be changed, we recommend that you would

change INPUT CH.

Touch INC button to move the cursor to “INPUT CH” and touch “SET” icon to activate the value

in red then select the channel to be connected to “OUTPUT CH” with INC and DEC buttons.

Touch “SET” icon again to deactivate the value. Touch INC button to move the cursor to

“MODE”