Operation Manual

Touch

•

TRIM

It is used to set the servo’s “Trim position”.

Touch “SET” icon then the values of CENTER and TRIM are activated in red. Adjust TRIM

values with INC and DEC buttons and touch “SET” icon again to deactivate the value. Touch

INC button to move the cursor to “LIMIT -”

NOTICE: When TRIM value is adjusted, the default value of CENTER, 1500usec, is automati-

cally set and the trim setup value is added to 1500usec.

•

LIMIT -, +

The function supports the adjustment of servo’s maximum travel amount for +,- direction.

Even the default value is 150%, the travel amount is limited to 100% that is programmed at

SERVO EPA of transmitter so 100%~150% range cannot be programmed and under 100%

range can be only programmed at “ LIMIT–“. Only if SERVO EPA of transmitter is set to

“150%”, you can set below 150% at LIMIT- value. Touch “SET” icon to activate the value in

red and adjust the value with INC and DEC buttons. Touch “SET” icon again to deactivate the

value and touch INC button to move the cursor to “PERIOD”.