Operation Manual

Touch

Telemetry

13. PIT >>RUDD

This function is used to correct the unintended movement of rudder during the ight of a

helicopter. It is not necessary when you make use of heading lock gyro

Touch “PITT >> RUDD” icon in the function page to call PIT >> RUDD setup page. You need

to mark the point on graph rst and then adjust the operation curve with “DEC”, “INC”, X-axis

and Y-axis buttons. Touch “ST OFF” icon to switch to “ST ON” then the pitch position line

appears on graph. Move throttle stick and place the line at the desired position between point

“L” and “H” then touch “ENT” icon on the bottom right. Now the new point is marked in graph.

By moving the pitch bar with the throttle stick, you should x the bar in the desired position

between L and H point. Now, touch the “ENT” icon on the bottom right side and then the new

point will appear. You may set ve points in your favorable position.

You need to mark the point on graph rst and then adjust the operation curve with “DEC”,

“INC”, X-axis and Y-axis buttons. Touch “ST OFF” to change to “ST ON” then the throttle

position line appears on graph. Move throttle stick and place the line at the desired position

between point “L” and “H” then touch “ENT” icon on the bottom right. Now the new point is

marked in graph. You can mark ve points between point “L” and “H” in the same way. Touch

ST ON” to switch to “ST OFF” and complete the point setup. Now touch “DEC” or “INC” button

to select point and touch X-axis or Y-axis to activate and then touch DEC” or “INC” button to

adjust the operation curve. Turn on the preset Q.LINK switch then you may adjust the opera-

tion curve of every Q.LINK as well.