Operation Manual

Gyro Suppression
TRIM
Gyro Suppression
TRIM
Touch
Touch
Touch
Touch
Touch
Touch
Gyro Suppression
TRIM
Gyro Suppression
TRIM
Gyro Suppression
TRIM
Gyro Suppression
TRIM
Gyro Suppression
TRIM
Touch
Touch
Gyro Suppression
TRIM
Gyro Suppression
TRIM
Gyro Suppression
TRIM
Gyro Suppression
TRIM
39
Telemetry
Gyro Gain, Governor, Governor RATE, Gyro Suppression are available in this function
- Gyro Gain is used to adjust the sensitivity of gyro. “00%” is basically set and heading lock
gyro is operated at over 40% of sensitivity. You may adjust sensitivity for each condition of
Q.LINK.
- Governor ACT is used to select “INH” or “ON” for Governor function. The default value is
“INH” and it should be set to “ON” to use Governor ACT by touching “INH” icon.
- Governor RATE is used to set the rate of Governor Function. You may adjust Governor
“RATE” for each condition of Q.LINK.
Touch “Gyr / Gover” icon to call the Gyr / Gover setup page. Touch the value in Gyro Gain
to activate in blue then adjust the value with “INC” and “DEC” buttons. Touch “INH” icon in
Governor ACT to switch it ON and then touch the value in Governor RATE to activate in blue.
Adjust the function value with “INC” and “DEC” buttons. We recommend you to adjust Gov-
ernor RATE for each condition of rotor RPM while a helicopter is hovering. Gyro Suppression
function is used to offset Rudder by adjusting the value of Piezo gyro, it is not used when to
use Head lock gyro Touch “BACK” icon on the left top to return FUNCTION page.