Operation Manual

Touch

TouchTouch

Touch Touch

Touch

10. TRIM STEP

It allows you to check all function values of “Digital trim step”, “DT1”, “DT2”, ‘Digital volume”,

and “Side slide”. Touch “Trim Step” icon in base menu page to call Trim Step setup page.

The step value indicates the amount that the trim is moved in the range, 100, when operating

trim key one time. “4” is set by default and it means that the trim is moved as much as “4” by

operating trim key one time.

Touch and activate the values in STEP line and adjust the values with INC” and “DEC” but-

tons. The programmed trim values are displayed in “POS” line and can be saved on transmit-

ter. If you save the programmed trim, the value is reset to the natural, 00%, and it can be ver-

ied in “POS” line as well. Touch and activate the values, 000%, in SET line and touch “SET”

icon in the right bottom then the value in POS line is switched to 000%, the programmed trim

value is saved in SET line.

After Trim STEP and SET setup, you may adjust the function value of “Digital trim 1” and

‘Digital trim 2”. Their default value is set as “None”. Touch any of options for ‘DT1” and “DT2”

to activate in blue. You may adjust the function value with “INC” and “DEC” buttons. Touch

“View” icon in the right to call the next page that you can see all setup data such as Trim posi-

tion, DT1, DT2, Digital volume and Side slide. Touch “BACK” icon to return the previous page.