Operation Manual

Touch Touch

Touch

8. TIMER

Timer function may be set for any desired time ,i.e. model time, date, time, etc. Two independ-

ent timers, TIMER1 and TIMER2, are provided for each model. Touch “Timer” icon in base

menu page to call the timer setup page.

To set the model time, touch “MODE” icon and then select “UP” or “DOWN”. The default value

is UP. Timer may be set count-down or count-up operation with your choice. Count-up timer

continues counting from zero to the setup time and Count-down timer keeps counting from the

setup time to zero.

After “MODE” setup, you need to set “ALARM”. The alarm sounds from the last 20 seconds

in the setup time. It has the 2 seconds intervals for the rst 10 seconds and has the 1 second

interval for the next 10 seconds.

In the “Timer” setup page, set “TIMER 1” rst. The timer in the rst line is used when to save

the ight data on SD card. Bind transmitter and receiver and Insert SD card into SD card slot

in the rear of transmitter. Touch the value in minute or second to operate or stop timer. The

ight data starts to be saved on SD card when timer starts to operate and stop to save when

timer stop to operate. Touch “T.RES” icon to reset timer. Since the timer in TIMER 1 is operat-

ed with ALARM timer at a time, you need to operated ALARM timer to use it

Touch