Operation Manual

Touch

- RANGE TEST

“Range Test” function reduces the power output. This allows for a range test to conrm the RF

link is operating correctly. Perform a range check at the beginning of each ying session to

conrm system operation.

If the servo connected to receiver is operated normally within 50m or 70m of the distance from

the receiver, you may y a model, if not, you need do range test again. If it doesn’t operate

normally even after the test, please send mz-12 for repair.

Touch “OFF” icon in “RANGE TEST” to change to “ON”, transmitter beeps indicating “Range

test” setup begins. This function is available for 99sec. you may touch “ON” icon if you want to

stop the function.

- DSC OUTPUT

It is used to set the number of channel when Trainer function is used with DSC jack. If 5

channels are used, PPM5 is recommended to use. To use more than 5 channels, choose the

appropriate PPM for each condition. PPM10, PPM16, PPM18, PPM24 are selectable.

Whenever you touch the value icon in DSC OUTPUT, You can select “PPM10”, “PPM16”,

“PPM18”, and “PPM 24” in turn. Default value is “PPM 10”.