Operation Manual

Touch

Touch Touch

Touch

- TX OUT SET

It is used to edit the receiver’s “out-channel” connected to each channel of transmitter as

you want. For example, when “2 Elevator” function is used, the “CH3” and “CH8” out pins of

receiver are used in the traditional channel setup, however, if the receiver’s CH4 pin is set for

the transmitter’s CH3 using “TX OUT SET” function, the CH4 and CH3 pin are operated for

the “2 ELEVATOR” function. To make use of this function, a receiver should be bound rst.

When you bind the receiver to RX1 and RX2 and then touch “Set” icon in “TX OUT SET” to

call “TX OUT SET” setup page. “TX OUT SET” page is differently shown according to the

number of receiver’s channel which is bound to a transmitter. Basically, the order of transmit-

ter’s channel is set as the same as the order of receiver’s out-pin. Touch the desired channel

number to activate in blue and change it to the channel that you want to match with “INC”

and “DEC” button and then touch “STO” icon to transmit the setup data to the receiver. The

other channels are set as the same as explained above.

NOTE: Since “TX OUT SET” function is set the receiver by transmitter, you should touch the

“STO” icon to transmit the setup data to the receiver and to save the data on a receiver for

operation.

- RF ON/OFF

It is used to turn on or off transmitter’s “RF” function. If you are not ying a model but pro-

gramming transmitter only, you are able to save the battery of the transmitter by setting RF to

turn off. Under “OFF” status, transmitter is disconnected with the receiver. Touch “ON” icon in

“RF ON/OFF” to change to “OFF”

- RF TYPE

mz-12 offers 2 RF types, NORMAL and FRANCE, to comply with country regulation.

“NORMAL” type is usually used in most countries, but you need France RF setting to comply

with France regulations in FANCE. France RF setting should only be turned on when operat-

ing your transmitter in France outdoors. “NORMAL” type can be changed into “FRANCE” type

by touching “NORMAL” icon. If the “FRANCE” icon is touched again, it can be changed into

“NORMAL” icon.