Operation Manual

Touch

1-6. CPY(Model Copy)

The Copy function is used to copy the programmed values of a model into the other model.

Touch the source model to copy, it is activated in blue. Now touch “CPY” icon on the right

bottom and touch the copy destination then it is activated in blue as well. The popup

message indicating the destination and source appear. Touch YES, if they are correct, then

“Please wait” message is displayed and a few seconds later, the source data is copied to the

copy destination.

transmitter.

2. Model type

It is used to reset the model type. Please note that all the value, excepting for model name,

is reset when “Model type” is reset. Touch “Model type” icon on base menu page to call the

model type setup page, the preset “model type”, “swash type” and “power type” is displayed.

The below example tells you how to change from the heli type to air type. If you touch M/

TYPE icon, you may select airplane form preset Helicopter at M/TYPE page again. In

accordance with the selected model type, ”Swash type” or “Wing type” appear. Since the air-

plane type is selected, the wing type is shown in the example below. Select the desired wing

type, tail type and power type in turn. If all procedures have been done correctly, all types

that you selected appear on the page. Touch ENT icon on the right bottom after checking the

selected types, Manual setting is completed and returned to base menu