Operation Manual

Touch

Check Check

Touch

1-3. INT.M (Internal Model)

It is used to copy the model memory in SD Card into the model list of transmitter. To make

use of INT.M function, you need SD Card that has the programmed model le. If you put SD

Card into SD Card slot on the back of transmitter, “SD Card” icon is lighted in the transmit-

ter main page. When the icon is lighted, touch the base setup icon to call the base setup

page. In the page, touch “Model Select” icon to call the “Model Sel” setup page and touch

the copy destination then it is activated in blue. Touch “INT.M” icon then the model list in SD

Card appears and then select the source model to copy. The popup message indicating the

destination and source appears. Touch YES, if they are correct, then “Please wait” message

is displayed and a few seconds later, the model data in SD Card is copied to the model list in

transmitter.