User manual

Set a value with INC or DEC on the right to the
outside at which the motor runs comfortably at your
desired idle speed or is for example defi nitely "off":
BACK
Graubele
ACT
CTL
SET
DEC


NORMAL
RES
INC
S
–123%
ON
INH
With a gas motor, make sure that the throttle
servo does not mechanically overtravel.
Assign the required ON/OFF switch (such as
S6) in the "CTL" line as described in detail in "Control,
switch and control switch assignment" on page 38:
BACK
Graubele
ACT
CTL
SET
DEC


NORMAL
RES
INC
S
–123%
SW 6
INH
In conclusion, touch the value fi eld in the "ACT" line to
release the option which is blocked by default ( INH ).
Depending on the switch position, the display of this
fi eld switches to ON or OFF .
BACK
Graubele
ACT
CTL
SET
DEC


NORMAL
RES
INC
S
–123%
SW 6
ON
Touch the SERVO button in the top right of the display
to open the graphic display of the servo travel and
positions described in greater detail on page 90 and
activate (if desired) the "Servo test" function integrated
in this display:
To go to the "Home menu", leave the "THR.CUT" display
by touching the BACK button at the top left:
BACK
Graubele
ACT
CTL
SET
DEC


NORMAL
RES
INC
S
–123%
SW 6
ON
Touch
BACK
SYSTEM
BASE
FUNCTION
Model Sel
E.P.A
Model Type
Rev/Slow
Sub-Trim
Motor
Timer
TX ctl
Fail Safe
Trim Step
Servo
Out.Swap
CH Set
73
Basic menu - Motor / THR.CUT
S1006_mz-24.3.en.indd 73 17.12.2014 15:21:41