User manual

Touch the icon for the model type in the basic transmit-
ter display with a fi nger or the provided stylus to directly
display the submenu "Model Type", or alternately touch
the gear icon labelled "B" to open the same menu from
the base menu:
000 000
000
000
mz
000%
000%
000
000
BATT TIME 00: 01: 23
Graubele
M 1
0:01:23
NORMAL
000:00.0
000:00.0
4.1V
RX TX
RX 00.0V
Touch
Touch
In the latter case, the display switches to the green base
menu. Touch the menu item "Model Type" with a fi nger
or the provided stylus.
BACK
SYSTEM
BASE
FUNCTION
Model Sel
E.P.A
Model Type
Rev/Slow
Sub-Trim
Motor
Timer
TX ctl
Fail Safe
Trim Step
Servo
Out.Swap
CH Set
Touch
Normally, the basic type of model is specifi ed when
creating the model memory in the submenu "Model
Sel" of the base menu (see page 45). In the "Model
Type" submenu, you can directly change the type of
the current model. When such a change is made, all
of the mixers, coupling functions, etc. for the previous
model type are also deleted or need to be adapted to be
changed type.
After you open the "Model Type" submenu, a graphic
display of the basic information of the current model
appears, for example:
Model Type
Change the model type
ACRO
2AILE
ELEC
AIRPLANE
T/TYPE
ELE.POWER
M/TYPE W/TYPE P/TYPE
NORMAL
Normal
ENT
WARNING
Once you change any of the existing
settings, all of the relevant parameters are
reset.
For example, the model memory with an airplane needs
to be reprogrammed for a helicopter model type.
Use a fi nger or the provided stylus to touch the fi rst fi eld
to be changed; in this example, the fi eld "Airplane":
ACRO
2AILE
ELEC
AIRPLANE
T/TYPE
ELE.POWER
M/TYPE W/TYPE P/TYPE
NORMAL
Normal
ENT
Touch
As described in detail in the section "Manually
programming the basic settings of a new model",
starting on page 45, the manual confi guration of a
model memory starts by selecting the basic model type.
As of fi rmware version V 1.023, the corre-
sponding selection window appears in modi-
fi ed form:
HELI
ACRO
GLID
HELICOPTER
AIRPLANE
GLIDER
BACK
OK
Are you sure?
Tapping BACK with your fi nger or the provided stylus
cancels the process. Tapping OK confi rms the process
and allows the model type to be selected:
HELI
ACRO
GLID
HELICOPTER
AIRPLANE
GLIDER
Following the example, touch the left button labelled
"Heli" in this display …
HELI
ACRO
GLID
HELICOPTER
AIRPLANE
GLIDER
Touch
… the display then switches to the selection of the
swash plate servo …
64
Basic menu - Model type
S1006_mz-24.3.en.indd 64 17.12.2014 15:21:37