User manual

• "1SERVO NOR"
You are using a flybar system, or the swashplate
is tilted by a roll and elevator servo. A separate
servo is used for the pitch control.
(Since helicopter models with only one pitch
servo that have three swashplate servos for pitch,
elevation and roll also operate without a mix of
functions in the transmitter as is usually the case
with flybar systems, the menu item "SWASH MIX,
page 192, normally does not appear on the
multifunction menu.)
• "2SERVO 180"
The swashplate is shifted axially for the pitch
control by means of two roll servos; the elevation
control is decoupled by means of a mechanical
compensation rocker.
• "3S 120 (Roll)"
Symmetrical three-point control of the swashplate
by means of three articulations points offset by
a 120°, by means of which one elevation servo
(front or rear) and two roll servos (to the left and
right side) are connected. All of the three servos
of the swashplate shift axially for pitch control.
• "3SERVO 140"
Asymmetrical three-point control of the
swashplate by means of three articulations
points offset by a 120°, by means of which one
elevation servo (front or rear) and two roll servos
(to the left side and right front) are connected. All
of the three servos of the swashplate shift axially
for pitch control.
• "3S 120 (Nick)"
Symmetrical three-point axis as before, but
rotated 90°; one roll servo on the side, and two
elevation servos, front and rear.
• "4SERVO 90"
Four-point control of the swashplate by means of
two roll servos and two elevation servos.
Swashplate type: 1 servo
2
Swashplate type: 2 servos
2
1
Swashplate type: 3 servos (2 roll)
3
1
2
Swashplate type: 3 servos (140°)
3
1
2
Swashplate type: 3 servos (2 elevation)
3
2
1
Swashplate type: 4 servos (90°) 2 elevation / 2 roll
2
5
1
3
Directly after you make your selection, the following
display appears:
• "Propulsion type"
… where you specify whether your helicopter is
driven by an electric motor or gas motor.
ELEC
GAS
ELECTRIC POWER
GAS POWER
After you select the propulsion mode, the assistant
takes you to the first model-dependent settings in the
following display …
49
Basic menu - Model selection
S1006_mz-24.3.en.indd 49 17.12.2014 15:21:29