User manual

ManualsBrandsGRAUPNER ManualsModel Making Remote ControlsMZ-18 HoTT Handheld RC 2,4 GHz No. of channels: 9 Incl. receiver

• "Tail type"

…, in which you can specify the type of your tail:

NOR

2ELE

NORMAL

V-TAIL

2ELEVATOR

Finish your entry by selecting …

• "Propulsion type"

… for your model

ELEC

GAS

ELECTRIC POWER

GAS POWER

Note:

The default for " Motor off " or "Idle" =

"Rear thro position" can be switched to

"Front thro position" for ﬁ xed-wing models

in the "THR.CRV" menu, page 144, by inverting the

control curve.

After the propulsion type has been selected, a

display appears with an overview of the previous

entries such as …

Entering the basic settings of a new model with an

wizzard

The previous section described the basic manual

programming of a ﬁ xed-wing model. In the following, the

assistant-controlled programming of a helicopter model

will be described.

As described under "Model Sel" on page 44, to set up

a new model, select a free model memory or a model

memory that has already been assigned but is no longer

required.

After touching NEW , a selection window appears in

the following screenshot as described in the previous

section. In this window, you can choose between MAN.

, manual processing, or WIZ. , assistant-controlled

programming, or press NO to terminate the process.

In the following menus, the necessary settings for a

ﬁ xed-wing model or helicopter are offered depending on

the selected model type.

Since the programming of a helicopter with the help of

an assistant is described in this section, touch the WIZ.

button with a ﬁ nger or the provided stylus:

BACK

MODEL NAME 1

SEL

NEW

IMP.M

EXP.M

RES

CPY

MODEL NAME 1

MODEL NAME 2

MODEL NAME 3

MODEL NAME 4

MODEL NAME 5

MODEL NAME 6

Select

MAN.

WIZ.

Touch

Note:

An example of manual model programming is

described in the previous section in the

context of programming a model with an

electric motor.

ACRO

2AILE

ELEC

AIRPLANE

T/TYPE

ELE.POWER

M/TYPE W/TYPE P/TYPE

NORMAL

Normal

ENT

…, which you can leave to go to the base menu by

touching the ENT button at the right bottom with a

ﬁ nger or the provided stylus:

BACK

SYSTEM

BASE

FUNCTION

Model Sel

E.P.A

Model Type

Rev/Slow

Sub-Trim

Motor

Timer

TX ctl

Fail Safe

Trim Step

Servo

Out.Swap

CH Set

Basic menu - Model selection

S1006_mz-24.3.en.indd 47 17.12.2014 15:21:28